Centrifuge Module Interface Operating Instructions Maintenance
092D0001-02 Rev. A page 65
Re-Installing the Hettich Unit
Perform the following steps to re-install the Hettich unit:
1. Close the drawer:
a. Verify that the Hettich unit has 4 buckets installed.
b. Close the lid.
c. At the top right of the control panel, turn the lid knob to the Locked
position.
d. Press the drawer lock release, the green button on the right drawer
slide, to release the drawer slide.
Figure 14: Reinstalling the Hettich Unit
1. Drawer handle
2. Drawer locking screws
3. Drawer lock release
WARNING
Do not grasp the outside of Hettich centrifuge unit to pull out or push in
the drawer. Only use the Hettich drawer handle to pull the drawer out or
push the drawer back in place. Failure to use the drawer handle while
moving the Hettich centrifuge unit can pose a pinch or crushing hazard.
To Next Page
Loading...
