System Operation Centrifuge Module Interface Operating Instructions
page 36 092D0001-02 Rev. A
3. Press the power button on the UPS panel to turn the UPS on.
Figure 3: Centrifuge Module Components
4. On the front of the interface computer, open the vertical panel and
press the power button.
5. Wait approximately 2 minutes for the interface computer to power on.
6. At the drive unit, move the power switch to the up position (On).
1. E-stop
2. Drive unit, behind the panel
3. Robot computer, behind the panel
4. UPS panel
5. Interface computer
6. Z-Up button
To Next Page
Loading...
