System Operation Centrifuge Module Interface Operating Instructions
page 38 092D0001-02 Rev. A
8. Press the robot computer power switch and wait approximately
2 minutes for the robot computer to power up.
Figure 5: Centrifuge Robot Computer Power Button
9. Close the panels.
10. On the LineMaster workspace station buttons, select Centrifuge.
The Details screen is displayed. The Centrifuge module is in a
Shutdown state.
11. On the States panel, select Online.
• The interface transitions to the Online state.
• The automation software and the Centrifuge module software
check communication links and safety features.
• The robot surveys the Centrifuge module to check for sample tubes
in the Centrifuge.
1. Robot computer power switch
To Next Page
Loading...
