Siemens FC18 Series User Manual

Operating Manual of FC18 Controller
Page: 62/70
APPENDIX 2 OPERABLE ITEM LIST
Controller:
Controller
Operational item
Auto/Manual * Set time System Check
FC1820
√ √ √
FC1840
√ √ √
FC186X
√ √ √
[ * ] Auto/Manual can only be switched through buttons on controllers.
Line:
Line
Operational item
Activation
/
Deactivation
Disable
/
Enable
Walk
-
test
/
Res
tore
Test
/
Res
tore
Reset
P2 line ------- -------
√ √
-------
Interlocking panel ------- ------- ------- -------
√
Main board input/output ------- ------- ------- ------- -------
Extinguishing panel ------- ------- ------- ------- -------
Point:
Device type
Operational item
Activation
/
Deactivation
Disable
Enable
Test
/
Walk-test/
Res
tore
Locate
/
Stop
Locating
Reset
FDCI181 Input module
-------- -------- -------- √ -------
FDCIO181 Input/output module
-------- -------- -------- √ --------
Auto alarm
device
FDO181 Smoke detector
-------
√ √ √ √
FDT181 Heat detector
Manual alarm
device
FDM181 Manual Call Point
-------
√ √ √ √
Supervision output
-------- √ -------- -------- --------
Alarm input
-------- √ √ -------- √
Status input
-------- √ -------- -------- --------
Output with confirmation /
output without confirmation
√ √ -------- -------- --------
FDCL181 Isolator -------
√ -------- √ --------
NAC
√ * √ -------- -------- --------
Interlocking input/output
√ √ -------- -------- --------
Printer -------
√
(Only for
test)
-------- --------
[ * ] NAC activation not only can be operated through menu, but also through <NAC Activation> key on the operation
panel.

Siemens FC18 Series Specifications

General

Brand	Siemens
Model	FC18 Series
Category	Controller
Language	English