Operating Manual of FC18 Controller
Page: 32/63
15. HOW TO LOCATE/STOP LOCATING
Function: To locate equipment.
Steps to locate:
1. Press “Menu” to browse the main menu (Fig. 15-1)
Main menu displayed.
2. Press “→” to select “Brow” submenu (Fig. 15-2). Press “↓” to select “All”,
then press “OK” to display the tree diagram (Fig. 15-3). Search down level
by level through stations, lines and points until you find the equipment you
are looking for.
3. Press “→” to pop out the shortcut menu (Fig.15-4). Use “↓” to select
“Locate” and press “OK” to locate the selected equipment. Now the test
indicator is flashing.
Steps to stop locating:
The same as the first 2 steps to conduct a remote test. The only difference
is that select “Stop locating” instead of “Locate” in step 3. Then press "OK"
to reset the selected equipment and turn off the flashing indicator.
Fig.15-1
Fig.15-2
Fig.15-3
Fig.15-4
To Next Page
Loading...
Need help?
General
