Operating Manual of FC18 Controller
Page: 63/63
APPENDIX 6 “STICKER METHOD”EASY FOR COMMISSIONING
In FD18 system, there is an exclusive ID number on each spot component. Engineer debug staffs can tear it down when
installing, and fix to the equipment position in engineering drawings, so that after installation of all components, engineer file
configuration can be made. Detailed operations are as follows:
1. Open the package.
2. Tear down the machine-readable ID number.
3. Fix it to the corresponding position in engineering drawings.
4. After all installation complete, turn on the system, and controller will find all new equipments.
5. Now the system is “auto configured” able to generate alarms and fault with default settings.
6. Upload the data to PC, and configure through debug tool software in PC:
- Choose the equipment.
- Enter text information or choose corresponding technical parameters (such as sensitivity).
7. After configuration, download to controller and complete the configuration job.
To Next Page
Loading...
Need help?
General
