Safety
13
Building Technologies A6V10210410_a_en_--
Fire Safety & Security Products 18.05.2009
Disclaimer
We have checked that the content of this document matches the hardware and
software described. Despite this, we cannot rule out deviations and cannot
therefore assume liability for them matching completely. The details in this
document are checked regularly and any corrections needed included in
subsequent editions.
We are grateful for any suggestions for improvement.
2.3 Standards and directives complied with
A list of the standards and directives complied with is available from your Siemens
contact.
2.4 Release Notes
Limitations to the configuration or use of devices in a fire detection installation with
a particular firmware version are possible.
WARNING
Limited or non-existent fire detection
Personal injury and damage to property in the event of a fire.
z Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
z Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
NOTICE
Incorrect planning and/or configuration
Important standards and specifications are not satisfied.
Fire detection installation is not accepted for commissioning.
Additional expense resulting from necessary new planning and/or configuration.
z Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
z Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
To Next Page
Loading...
