EVAC connector board FTI2002-N1[NL]
90
Building Technologies A6V10210410_a_en_--
Fire Safety & Security Products 18.05.2009
19.2 Pin assignments
The EVAC-NL connector board FTI2002-N1 is used as an interface from the
EVAC-NL operating unit FTO2007-N1 to the RS485 card in the control panel.
Peripheryboard
FTO2007
PMI & Mainboard
FCM72xx
FTO2007
RS485
FCA2002
FTI2002
FC72x
Vsys
RS485
Vext.
FTI2002
X1
X1
X1
X1
X4
X4
FCM7221-H3
1
2
X400
X402
Wiring of the EVAC-NL connector board FTI2002-N1 in a remote EVAC 20-zone indicator
1 Any housing (e.g. ECO housing)
2 Operating add-on FCM7221-H3
FTI2002 EVAC-NL connector board
FTO2007 EVAC-NL operating unit
The two EVAC-NL operating units FTO2007-NL must be linked via the peripheral
data bus for synchronization (X400 – X402). If the LED indicators on the two
components do not flash in synch, this indicates that they are not connected to one
another.
To Next Page
Loading...
