Virtual Network configuration
A31003-W1040-U101-1-7619, July 2006 DRAFT
142 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Authentication for a VNS
● No Captive Portal Support
● Internal Captive Portal – Define the parameters of the internal Captive Portal page
presented by the HiPath Wireless Controller, and the authentication request from the
HiPath Wireless Controller to the RADIUS server.
● External Captive Portal – Define the parameters of the external Captive Portal page
presented by an external server. The authentication can be carried out by an external
authentication server or by the HiPath Wireless Controller request to a RADIUS server.
For more information on configuring Captive Portal settings, see Section 7.3.2.2, “To configure
the Captive Portal settings for internal Captive Portal:”, on page 142 or Section 7.3.2.2, “To
configure the Captive Portal Settings for external Captive Portal:”, on page 144.
To configure the Captive Portal settings for internal Captive Portal:
1. From the main menu, click Virtual Network Configuration. The Virtual Network
Configuration screen appears.
2. In the left pane Virtual Networks list, click the VNS you want to configure the Captive Portal
settings for. The Topology tab is displayed.
3. Click the Auth & Acct tab.
To Next Page
Loading...
