Siemens MAMMOMAT Novation DR - Settings Date and Time; Brick

10 - 1
Siemens AG SPB7-250.815.02 Page 1 of 4 MAMMOMAT Novation
DR
Medical Solutions Rev. 02 09.04 CS SD 24 System
Final procedures 10
Settings date and time 10
MAMMOMAT Stand
Prerequisite
• The correct date and time must be set in the service PC. If not, set the date at C:\> by
typing date <ENTER> and the time at C:\> by typing time <ENTER>.
Test performance
1. Start the Service Software for the MAMMOMAT Stand on the Service PC.
2. In the Mainmenu select Configuration  Clock.
3. Press <F2>.
With <F2> the date and time set in the service PC are taken over by the
MAMMOMAT stand.
BRICK 10
Setting the date and time on the BRICK.
1. Go into the service software and select Utilities -> Escape to OS and enter the
following command in the command field.
start telnet brick
2. A username and password have to be entered.
Username: root
Password: ******
Fig. 1 MAMMOMAT Stand clock adjustment