Tap and hold using 2 fingers
● Open cycles line by line to change (without input screen
form)
Tapping with 2 index fingers – only for 840D sl
● Tap with two fingers simultaneously in the lower right- and
left-hand corners to open the TCU menu.
The menu has to be opened for service purposes.
Note
Flicking gestures with several fingers
The gestures only function reliably if you hold your fingers sufficiently far apart. The fingers
should be at least 1 cm apart.
Multitouch operation with SINUMERIK Operate
3.3 Finger gestures
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 73
To Next Page
Loading...
Need help?
General
