16.7.3 Contour milling with manual machine
The same range of technological functions (cycles) is available as in automatic mode for
contour milling of simple geometric shapes:
⇒ ⇒
⇒
⇒ ⇒
⇒
Parameter
The parameters of the input screen forms correspond to the parameters under Automatic (see
Section Contour milling (Page 481)
16.7.4 Turning with manual machine - milling/turning machine
Functions (cycles)
The same range of technological functions (cycles) is available as in automatic mode for the
turning of simple geometric shapes:
⇒
⇒
Working with Manual Machine
16.7 More complex machining
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 845
To Next Page
Loading...
Need help?
General
