3. Press the <SELECT> key.
The "Network Title / Comment" window opens and shows the title and a
possibly assigned comment for the selected network.
5. Press the "Change" softkey.
The fields can be edited.
Note:
To insert a line break in comment, use the key combination <ALT> +
<INPUT>.
6. Enter the changes and press the "OK" softkey to transfer the data to the
user program.
23.5.9 Displaying the network symbol information table
All of the symbolic identifiers used in the selected network are displayed in the "Network
Symbol Information Table" window.
The following information is listed:
● Names
● Absolute addresses
● Comments
The symbol information table remains empty for networks that do not contain any global
symbols.
Procedure
1. The ladder diagram display (LAD) is open.
2. Select the desired network and press the "Symbol info" softkey.
The "Network Symbol Information Table" window appears.
3. Use the cursor keys to move within the table.
Edit PLC user program (828D only)
23.5 View of the program blocks
Milling
920 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
