The program is included in the assignment list.
Assigned ShopMill programs that are not in the folder in which you create
the multiple clamping program, are displayed with the complete path
7. Place the cursor on the desired program and press the "Delete selection"
softkey if you want to remove individual programs from the assignment
list.
- OR -
Press the "Delete all" softkey if you want to remove all programs from the
global program.
8. Press the "OK" softkey when the assignment list is complete.
This optimizes the tool changes.
The global program is then renumbered. The number of the current
clamping is specified every time the program switches from one clamping
to another.
Apart from the global program (XYZ.MPF), the file XYZ_MCD.INI is also
set up in which the assignment between work offsets and programs is
stored. Both programs are stored in the directory that was previously
selected in the Program Manager.
Note
If you switch from the assignment list (without canceling) to another function and then call the
"Multiple clamping" function later, the same assignment list is displayed again.
Managing programs
14.20 Multiple clamping
Milling
808 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
