Siemens MOBILETT Plus HP Maintenance Instruction

8 General
MOBILETT Plus HP SPR8-220.101.04.03.02 Siemens AG
07.05 CS PS 24
Page 8 of 64
Medical Solutions
1.4 Required tools, measurement and auxiliary devices
NOTE
All tools, measurement and auxiliary devices, with the exception of
those marked " * " , are listed in the STC (Service Tools Catalogue)
along with their specifications.
• Standard service equipment*
• Digital multimeter
• kV measurement device (works with the filter comparison method) or storage oscillo-
scope with ± 2.5 % accuracy
• Storage oscilloscope with ± 2.5 % accuracy
• Protective ground/earth meter
• Equivalent leakage current meter
• Torque wrench 6 - 12 Nm
• Torque wrench 20 - 25 Nm
• Lux meter (only for USA)
• Spring scale for 350 N
• Dose meter (only for USA or if optional ‘DAP measuring system‘ is installed)
• Cable (min. 4 m long; min. 1000 N tensile strength)*
• 2 pieces of wood, approximately 50 x 75 x 500 mm (2.5 x 3 x 20 inches)*
• Calibration tool for ‘DAP measuring system‘, part no. 65 84 978

Siemens MOBILETT Plus HP Specifications

General

Brand	Siemens
Model	MOBILETT Plus HP
Category	Medical Equipment
Language	English