Siemens MOBILETT Plus HP Maintenance Instruction

20 General
MOBILETT Plus HP SPR8-220.101.04.03.02 Siemens AG
07.05 CS PS 24
Page 20 of 64
Medical Solutions
1.14 Technical Safety Checks (TSC)
Abbreviation: TSC = Technical Safety Checks
NOTE
• Within the purview of DIN VDE 0751-1, the operator of medical
engineering products has to perform technical safety checks at
regular intervals.
• The checks listed in these maintenance instructions contain all
technical safety checks according to DIN VDE 0751-1 – except
for the checks of the completeness, presence and legibility of
the necessary operator documents.
• A separate protocol with the print number SP00.000.834.01... is
available for each technical safety check.
• Within the purview of DIN VDE 0751-1, we recommend docu-
menting the results of the maintenance both in the mainte-
nance protocol and in the TSC protocol. The protocols should
be filled out completely and handed over to the client after the
maintenance is completed.
• In the table below, each technical safety check listed in the doc-
ument SP00.000.834.01... is assigned to the corresponding
maintenance work.
Technical Safety Checks,
Test Certificate - check
Maintenance instructions – check/
Comments
1 Identification data Please fill in the fields.
2 General checks n.a.
2.1 Visual inspection: Are there any dam-
ages affecting safety?
2.1.1 Damage, checks:
SIM Covers
SIM Cassette compartment
SIM Control and display panel
SIM Exposure release cable
SIM Single tank generator
SIM Collimator
2.2 Are all cables and cable guides firmly
attached and in place, without any visible
damage?
2.2.9 Mains cable, checks:
SIM Damage
SIM Cable winder
SIM Protective conductor
2.2.11 Arm cable harness, check:
SIM Damage

Siemens MOBILETT Plus HP Specifications

General

Brand	Siemens
Model	MOBILETT Plus HP
Category	Medical Equipment
Language	English