Siemens NXAIR - 12 Operating the Metering Panel; Control Elements at the Front Side of the Panel; Position Indicator Visible on High-Voltage Door

110-0134.9 / 13 NXAIR / ≤ 40 kA 102
Operating the metering panel
12 Operating the metering panel
INFORMATION
Read and understand these instructions before attempting operating works.
12.1 Control elements at the front side of the panel
(1)
Door to the low-voltage compartment
(2)
Protection device
(3)
Locking device for the door to the low-voltage
compartment
(4)
Instruction label for closing the high-voltage door
(5)
Handle for opening the high-voltage door
(6)
Actuating opening for inserting the double-bit key to
control racking of the withdrawable metering
part / metering truck
(7)
Mechanical position indicator for withdrawable
metering part / metering truck
(8)
High-voltage door
(9)
Actuating opening for racking the withdrawable
metering part / metering truck
(10)
Operating slide for opening and closing the
actuating opening for racking the withdrawable
metering part / metering truck
(11)
Test sockets for busbar voltage detecting system
(type LRM) as additional component
Fig. 166: Control elements on
the panel front
12.2 Position indicator visible on high-voltage door
Indicator for position of withdrawable metering part / metering truck:
Position indications for:
Service position
Intermediate position
Test position