Operating the contactor panel with panel width 600 mm
110-0134.9 / 14 NXAIR / ≤ 40 kA 167
Move the lever for the manual unlocking to the left as far as it will go. Fit the padlock to the
lever and close it.
Fig. 294: Moving the lever to the left
Fig. 295: Lever is padlocked
Push the racking crank for moving the contactor truck onto the operating shaft, and turn
counter-clockwise as far as it will go.
Remove the racking crank for moving the contactor truck.
Turn the double-bit key counter-clockwise as far as it will go (that is 90°) to interlock the
contactor truck.
Fig. 296: Turning the racking crank
counter-clockwise
Fig. 297: Turning the double-bit key
counter-clockwise
Remove the double-bit key.
To Next Page
Loading...
