Accessing the connection compartment through the front
316 NXAIR / ≤ 40 kA 110-0134.9 / 14
Make sure not to dent the links on the panel base while performing any further removal and
installation work.
Fig. 584: 2 links on panel base
Fig. 585: Link bent in correct position
Remove the connecting elements (2) from the protection plate (1), and store it:
• 4 nuts M8 with contact washers
Remove the protection plate (1), and store it.
Fig. 586: 4 bolted joints on protection plate
Remove the connecting elements from the partition to the connection compartment (3) inside
the switching-device compartment, and store it:
• 10 bolts M8x20 with contact washers and plain washers size 8
acc. to ISO 7093 (4)
• 5 bolts M8x20 with contact washers (5)
To Next Page
Loading...
