802-9081.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 11 143/293
Installation
15.12 Installing the switchgear termination
➭ Bolt the switchgear termination together with the front and rear edge of the end panel
using 12 self-tapping bolts size M5 each.
➭ Mount the termination angle at the upper edge of the panel.
➭ In panels without pressure relief duct, press the end cover firmly to the wall and tighten the
bolts. If applicable, fasten to the wall.
INFORMATION
The end panel of the NXPLUS C switchgear is delivered as standard with pre-assembled
switchgear termination and termination angle.
If the customer ordered without pre-assembled switchgear termination and termination
angle, perform the following work operations.
To Next Page
