Siemens NXPLUS C

802-9081.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C • Revision 11 157/293
Installation
➭ Insert the next floor plate in the notch of the rubber sleeve.
Fig. 111: Example for panel width 900 mm
➭ Bolt the floor plate tight.
Fig. 112: Example for panel width 600 mm
➭ Mount further floor plates.
Mounting the termination
plate
➭ Push the termination plate under the last floor plate and set it on the studs.
Fig. 113: Example for panel width 900 mm
➭ Bolt the floor plate and the termination plate together using 4 bolts and washers.
Fig. 114: Example for panel width 600 mm