Siemens optiPoint 500 basic User Manual

Step by Step
Displaying and Assigning Call Charges
70
Displaying and Assigning Call
Charges
Displaying Call Charges (Not for U.S.)
For the current call:
The display usually shows call charges at the end of a
call (default setting).
If you wish to display charges continuously during a call
in progress, your service personnel must request this
feature from your carrier.
Indication of the cost of a telephone call has to be re-
quested from the service provider and has to be in-
stalled by an authorized technician.
Depending on the setting, during or after the call, the
display will show the cost of the telephone call.
Some carriers also let you display toll-free external calls.
The message "Free of Charge" appears on the screen ei-
ther before or during the call.
If the cost indication facility has not been installed, the
display will show the dialled number and/or the length
of the telephone call.
For all calls and the last one conducted:
The connection charges for the last chargeable call con-
ducted are displayed first. Five seconds later, the total
accumulated connection charges appear.
Press the key. The LED lights up.
> : Select and confirm
1
.
or
qji Enter the code.
If a call is transferred, the charges are assigned to
the telephone to which the call was transferred.
Program/Service
*
65=Show call charges?
[1] ”Different Displays in a HiPath 4000 Environment
(Not for HiPath 500)” Æ Page 120
If an optiPoint application module is connected
to your telephone, the "Terminal Mode" is activa-
ted once the function is started Æ Page 117.
The prompts are now shown on the optiPoint ap-
plication module display.
You can use the keys on the optiPoint application
module.

Siemens optiPoint 500 basic Specifications

General

Brand	Siemens
Model	optiPoint 500 basic
Category	Telephone
Language	English