Siemens Profiset 3030 - Programming the keys

Miscellaneous functions
103
Step by step
For the current call:
The call charge is shown on the display at the end of the
call (Standard)
If you would like to see the charges while the calls are
in progress, ask your system’s support technician to re-
quest activation of the AOCD (Advice of Charge During
the Call) facility from your local Carrier.
Depending on the Carrier, toll-free calls will also be
shown. Before or during a call the display will read
"FREE OF CHARGE".
When a call is transferred the call charge is assigned to
the extension that received the transfer.
For all calls that were made and have a remaining
balance:
First, the total charges are displayed (total for all calls
made). After five seconds the remaining balance is dis-
played, if the support technician has configured a Call
Charge limit.
Press to access the Service menu.
Select and confirm.
or
qji Enter the code to enable call charge consultation.
Programming the keys
1
The key programming feature allows an extension to as-
sign functions to a system telephone’s programmable
keys.
Procedure for programming the keys
Press to access the Service menu.
Select and confirm.
or
qme Enter the programming code a key.
*65=SHO CHRGS ?
[1] For system telephones without a display, only the "Store key num-
ber" can be programmed. Other functions can only be programmed
using the HiPath 1100 System Manager.
*91=PRG. KEY?