Siemens Profiset 3030 - For Fax;DID

Step by step
Functions used when receiving calls
62
or
qeh Enter the code for internal call forwarding.
p Enter the number for the
1. Extension you want to call (e.g., 11/101).
2. UCD subscriber group for voice mail (e.g., 790).
3. Call group (e.g 770)
4. Access to an external line (e.g., 0) and the external
destination number.
Confirm.
If call forwarding is activated, the display will show
"FORWARD TO:" during a period of time.
For Fax/DID
1
When a Fax/DID module is installed, calls can be for-
warded to Auto-answering mode.
p Enter the type of call forwarding wanted:
1.
qee - Direct call forwarding
2.
qeh - Call forward no answer
3.p
Enter the call forwarding destination number.
1.
khd - FAX
Call forward to FAX is indicated on the display.
2. khe - Attendant (direct dialing to extension)
Call forward to DID is indicated on the display.
3. khf - Fax/DID
Call forward to DID/FAX is indicated on the display.
4. khg - Message
Call forward to Greeting is indicated on the display.
Confirm.
SAVE?
FORWARD TO:
[1] For further information about the Fax/DID module, see Fax/DID
Auto-answering mode in the Programming manual.
TO: FAX
TO: DID
TO: FAX/DID
TO: ANNOUNCEMENT
SAVE?