Siemens Profiset 3030 - Transfer

Functions used during calls
45
Step by step
qd
Enter the code to return to the first call.
w s Wait to return. Proceed with the conversation.
Transfer
1
The Transfer feature allows an extension to transfer a
call (incoming or outgoing) to another extension or to an
external number.
Required: A call must be in progress.
Select and confirm.
p Enter the extension or external number.
Optional (s) Let the caller know that there is a second call.
Confirm.
or
t or Replace the handset or press the SPEAKER key
External-to-external over an analog trunk
2
When there is an external call in progress, an extension
can make a consultation to another external number
and transfer the call, as described above.
Once the call is transferred and answered at the desti-
nation, a disconnect timer is activated (default is 5 min-
utes). A 20-second warning tone is sent to both parties
before the call is disconnected. In order to continue the
call without disconnecting, the destination number
must enter a code (MF, default "00") to restart the time-
out., The call disconnect timeout and the Code to reset
it are configurable. Please ask your system’s support
technician for further information.
[1] If a transfer’s destination extension does not answer, the call is re-
turned to the calling extension.
An external-to-external transfer can only be made when at least
one of the calls is an outgoing call.
A call cannot be transferred to an entrance telephone, neither can
an entrance telephone transfer a call.
TRANSFER?
TRANSFER?
[2] A call is terminated under three conditions:
• Disconnect timeout after and external-to-external transfer (Code
183);
• When a busy signal is detected;
• Type of answering signal (Code 158) detected.