Landis & Staefa Division CC1B7865E February 10, 2000 11/56
3. Installation
The front panel can be cleaned with normal washing and rinsing agents or detergents.
*
It is
not
resistant to corrosive acids, caustic solutions and abrasive cleaners, or
cleaning with high-pressure cleaners!
The controller module can be removed from the housing for servicing.
The rules of DIN EN 100 015 «Protection of electrostatically sensitive devices »
must be adhered to for internal work on the controller!
No liability
will be
accepted for damage caused by electrostatic discharge.
7865z09/0200
✱
✱✱
✱
Press the ribbed surfaces together (at top and bottom) and pull out the controller
module.
3.5. Cleaning the front panel
3.6 Removing the controller module
To Next Page
Loading...
Need help?
General
