Siemens RWF40 Series User Manual

4/56 CC1B7865E February 10, 2000 Landis & Staefa Division
Operation ............................................................................................29
Basic display................................................................................................................ 30
Meaning of the display and buttons............................................................................... 30
User level......................................................................................................................31
Changing the setpoints.................................................................................................. 31
Manual operation of a modulating burner...................................................................... 33
Manual operation of a two-stage burner........................................................................ 33
Start self-setting ............................................................................................................ 34
Display of the software version and unit of actual value ............................................... 34
Parameter level............................................................................................................ 35
Enter parameters........................................................................................................... 35
Configuration level ...................................................................................................... 35
Changing the configuration code................................................................................... 35
Parameter settings .............................................................................36
Configuration......................................................................................38
C111
inputs............................................................................................................ 38
C112
limit comparator, controller type, setpoint «SP1», locking ..................... 40
C113
unit address, dimensional unit, out-of-range............................................ 44
SCL
scaling of standard signal range start, analog input 1................................... 45
SCH
scaling of standard signal range end, analog input 1.................................... 45
SCL2
scaling of standard signal range start, analog input 2................................... 45
SCH2
scaling of standard signal range end, analog input 2.................................... 46
SPL
lower setpoint limit......................................................................................... 46
SPH
upper setpoint limit ........................................................................................ 46
OFF1
actual value correction for analog input 1 ..................................................... 46
OFF2
actual value correction for analog input 2 ..................................................... 46
OFF3
actual value correction for analog input 3 ..................................................... 46
dF1
2
nd
order digital filter for analog input 1 ......................................................... 46
Self-setting function...........................................................................47
Self-setting function in high-fire operation ............................................................... 47
Checking the controller parameters .......................................................................... 49
What to do if........................................................................................50
...numbers are flashing on the display ...................................................................... 50
6.
6.1
6.1.1
6.2
6.2.1
6.2.2
6.2.3
6.2.4
6.2.5
6.3
6.3.1
6.4
6.4.1
7.
8.
8.1
8.2
8.3
8.3.1
8.3.2
8.3.3
8.3.4
8.3.5
8.3.6
8.3.7
8.3.8
8.3.9
8.3.10
9.
9.1
9.2
10.
10.1

Siemens RWF40 Series Specifications

General

Brand	Siemens
Model	RWF40 Series
Category	Controller
Language	English