Siemens RX1400 - Disabling Spanning Tree Globally

Chapter 7
Examples
RUGGEDCOM NETCONF
Reference Guide
92 Disabling Spanning Tree Globally
4. Define the static route:
<rpc message-id="233" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config>
<routing xmlns="http://ruggedcom.com/ns/rmf_routing">
<static>
<ipv4>
<route>
<network>10.200.16.0/20</network>
<via>
<gw>172.30.128.1</gw>
</via>
</route>
</ipv4>
</static>
</routing>
</config>
</edit-config>
</rpc>]]>]]>
5. Commit the changes:
<rpc message-id="234" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<commit/>
</rpc>]]>]]>
6. Unlock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="235">
<unlock>
<target>
<candidate/>
</target>
</unlock>
</rpc>]]>]]>
7. Unlock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="236">
<unlock>
<target>
<running/>
</target>
</unlock>
</rpc>]]>]]>
Section7.17
Disabling Spanning Tree Globally
In this example, multiple <rpc> requests globally disable spanning tree in the candidate configuration and then
commit the changes.
The following is the recommended procedure for making configuration changes on a device. This procedure also
shows how to delete data with the nc:operation="delete" attribute.
1. Lock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="230">