Siemens RX1400 - Clear-Stp-Stats (Switch); Flush-Dynamic-Rules (Switch); Reset-All-Switch-Ports (Switch)

Chapter 6
RUGGEDCOM ROX II Actions
RUGGEDCOM NETCONF
Reference Guide
70 clear-stp-stats (Switch)
• Section6.4.2, “flush-dynamic-rules (Switch)”
• Section6.4.3, “reset-all-switch-ports (Switch)”
• Section6.4.4, “clear-all-switch-stats (Switch)”
• Section6.4.5, “clear-cable-stats-all (Switch)”
Section6.4.1
clear-stp-stats (Switch)
This action clears the spanning-tree protocol statistics. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<switch xmlns="http://ruggedcom.com/ns/rmf_ifswitch">
<spanning-tree>
<clear-stp-stats/>
</spanning-tree>
</switch>
</data>
</action>
</rpc>]]>]]>
Section6.4.2
flush-dynamic-rules (Switch)
This action deletes all dynamic entries from the routing-rules-summary table. This action does not take any
parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<switch xmlns="http://ruggedcom.com/ns/rmf_ifswitch">
<layer3-switching>
<flush-dynamic-rules/>
</layer3-switching>
</switch>
</data>
</action>
</rpc>]]>]]>
Section6.4.3
reset-all-switch-ports (Switch)
This action resets all switch ports. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<switch xmlns="http://ruggedcom.com/ns/rmf_ifswitch">
<reset-all-switch-ports/>
</switch>
</data>