Siemens RX1400 - Decline-Upgrade; Rollback-Reboot

Chapter 6
RUGGEDCOM ROX II Actions
RUGGEDCOM NETCONF
Reference Guide
56 decline-upgrade
<software-upgrade>
<launch-upgrade/>
</software-upgrade>
</admin>
</data>
</action>
</rpc>]]>]]>
Section6.1.3
decline-upgrade
This action declines a RUGGEDCOM ROX II software upgrade. After an upgrade occurs and while the system is
awaiting a reboot to the upgraded partition, use the <decline-upgrade> action to cancel the attempt to run
the upgraded partition. This action also unlocks all configurations locked by the <launch-upgrade> process. If
no update has been applied, or if the device is not awaiting a reboot after applying an update, this action has no
effect.
This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<software-upgrade>
<decline-upgrade/>
</software-upgrade>
</admin>
</data>
</action>
</rpc>]]>]]>
Section6.1.4
rollback-reboot
This action boots the device to a previous software release on the alternate partition. This action does not take any
parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<software-upgrade>
<rollback-reboot/>
</software-upgrade>
</admin>
</data>
</action>
</rpc>]]>]]>