Siemens RX1400 - Clear-Port-Stats (Switch Port); Start-Cable-Test (Switch Port)

Chapter 6
RUGGEDCOM ROX II Actions
RUGGEDCOM NETCONF
Reference Guide
66 clear-port-stats (Switch Port)
Section6.2.9
clear-port-stats (Switch Port)
This action clears the port statistics for the specified switch port. Specify the switch module and port in the
<module> and <port> elements. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<switch>
<slot>{module}</slot>
<port>{port}</port>
<clear-port-stats/>
</switch>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {module}
The module number for the switch port.
• {port}
The port number for the switch port.
Section6.2.10
start-cable-test (Switch Port)
This action starts cable test diagnostics on the specified switch port. Specify the switch module and port in the
<module> and <port> elements. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<switch>
<slot>{module}</slot>
<port>{port}</port>
<diagnostics>
<start-cable-test/>
</diagnostics>
</switch>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {module}
The module number for the switch port.
• {port}
The port number for the switch port.