Siemens RX1400 - Reset (Serial Port); Clear-Serial-Port-Stats

Chapter 6
RUGGEDCOM ROX II Actions
RUGGEDCOM NETCONF
Reference Guide
64 reset (Serial Port)
</cellmodem>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {module}
The module number for the cellular modem.
• {port}
The port number for the cellular modem.
• {atCommand}
The AT command to send to the modem. The command must begin with the prefix AT.
Section6.2.5
reset (Serial Port)
This action resets the specified serial port. Specify the serial module and port in the <module> and <port>
elements. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<serial>
<module>{module}</module>
<port>{port}</port>
<reset/>
</serial>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {module}
The module number for the serial port.
• {port}
The port number for the serial port.
Section6.2.6
clear-serial-port-stats
This action clears the port statistics for the specified serial port. Specify the serial module and port in the
<module> and <port> elements. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<serial>
<module>{module}</module>
<port>{port}</port>
<clear-serial-port-stats/>