Siemens RX1400 - Clear-All-Switch-Stats (Switch); Clear-Cable-Stats-All (Switch); Tunnel Namespace Actions

RUGGEDCOM NETCONF
Reference Guide
Chapter 6
RUGGEDCOM ROX II Actions
clear-all-switch-stats (Switch) 71
</action>
</rpc>]]>]]>
Section6.4.4
clear-all-switch-stats (Switch)
This action clears all switch statistics. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<switch xmlns="http://ruggedcom.com/ns/rmf_ifswitch">
<clear-all-switch-stats/>
</switch>
</data>
</action>
</rpc>]]>]]>
Section6.4.5
clear-cable-stats-all (Switch)
This action clears all cable test diagnostic statistics. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<switch xmlns="http://ruggedcom.com/ns/rmf_ifswitch">
<clear-cable-stats-all/>
</switch>
</data>
</action>
</rpc>]]>]]>
Section6.5
Tunnel Namespace Actions
This section describes how to perform actions related to tunnel namespaces using <rpc> messages through
NETCONF.
CONTENTS
• Section6.5.1, “display-public-key (IPSEC)”
• Section6.5.2, “status (IPSEC)”
• Section6.5.3, “install-certificate (IPSEC)”
• Section6.5.4, “install-ca-certificate (IPSEC)”
• Section6.5.5, “install-crl-file (IPSEC)”
• Section6.5.6, “remove-ca-certificate (IPSEC)”
• Section6.5.7, “remove-certificate (IPSEC)”