Siemens RX1400 - Reset (Modem); At (Modem)

Chapter 6
RUGGEDCOM ROX II Actions
RUGGEDCOM NETCONF
Reference Guide
62 reset (Modem)
• Section6.2.2, “at (Modem)”
• Section6.2.3, “reset (Cellular Modem)”
• Section6.2.4, “at (Cellular Modem)”
• Section6.2.5, “reset (Serial Port)”
• Section6.2.6, “clear-serial-port-stats”
• Section6.2.7, “restart-serserver”
• Section6.2.8, “reset-port (Switch Port)”
• Section6.2.9, “clear-port-stats (Switch Port)”
• Section6.2.10, “start-cable-test (Switch Port)”
• Section6.2.11, “clear-cable-stats-port (Switch Port)”
Section6.2.1
reset (Modem)
This action resets the modem. Resetting the modem takes approximately 15 seconds. Resetting the modem
terminates the PPP connection.
Specify the modem interface name in the <ifname> element. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<modem>
<ifname>{interfaceName}</ifname>
<reset/>
</modem>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {interfaceName}
The interface name for the modem.
Section6.2.2
at (Modem)
This action sends an AT command to the modem. The command must begin with the prefix AT.
Specify the modem interface name in the <ifname> element. This action takes a single parameter: <command>.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<modem>
<ifname>{interfaceName}</ifname>
<at>
<command>{atCommand}</command>
</at>