Siemens RX1400 - Services Namespace Actions

RUGGEDCOM NETCONF
Reference Guide
Chapter 6
RUGGEDCOM ROX II Actions
snmp-discover 55
• Section6.1.11, “restore-factory-defaults”
• Section6.1.12, “delete-logs”
• Section6.1.13, “install-files”
• Section6.1.14, “backup-files (Backup Files)”
• Section6.1.15, “full-configuration-save”
• Section6.1.16, “full-configuration-load”
Section6.1.1
snmp-discover
This action discovers the SNMP engine ID for a given IP address and port. Parameters include the {ip address},
{port}, and {trap-port}.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<snmp>
<snmp-discover>
<address>{ipAaddress}</address>
<port>{port}</port>
<trap-port>{trapPort}</trap-port>
</snmp-discover>
</snmp>
</admin>
</data>
</action>
</rpc>]]>]]>
• {ipAddress}
The SNMP IP address the device listens on.
• {port}
The SNMP data port the device listens on (if any).
• {trapPort}
The SNMP trap port the device listens on (if any).
Section6.1.2
launch-upgrade
This action launches a RUGGEDCOM ROX II software upgrade to the alternate partition on the device. The
repository address and target release must be configured in admin/software-upgrade/upgrade-settings.
A reboot is required to run the new software release in the alternate partition. All configurations are locked from
the start of the upgrade to the subsequent reboot.
This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">