Siemens RX1400 - Full-Configuration-Load; Interfaces Namespace Actions

RUGGEDCOM NETCONF
Reference Guide
Chapter 6
RUGGEDCOM ROX II Actions
full-configuration-load 61
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<full-configuration-save>
<format>{format}</format>
<file-name>{fileName}</file-name>
</full-configuration-save>
</admin>
</data>
</action>
</rpc>]]>]]>
• {format}
The format for the configuration file: cli.
• {fileName}
The name for the configuration file.
Section6.1.16
full-configuration-load
This action loads a configuration from the specified file found in the /var/lib/config directory on the device.
Parameters include <format> and <file-name>.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<admin xmlns="http://ruggedcom.com/ns/rmf_admin">
<full-configuration-load>
<format>{format}</format>
<file-name>{fileName}</file-name>
</full-configuration-load>
</admin>
</data>
</action>
</rpc>]]>]]>
• {format}
The format for the configuration file: cli.
• {fileName}
The name for the configuration file.
Section6.2
Interfaces Namespace Actions
This section describes how to perform actions related to interface namespaces using <rpc> messages through
NETCONF.
CONTENTS
• Section6.2.1, “reset (Modem)”