Siemens RX1400 - Reset (Cellular Modem); At (Cellular Modem)

RUGGEDCOM NETCONF
Reference Guide
Chapter 6
RUGGEDCOM ROX II Actions
reset (Cellular Modem) 63
</modem>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {interfaceName}
The name of the modem interface.
• {atCommand}
The AT command to send to the modem. The command must begin with the prefix AT.
Section6.2.3
reset (Cellular Modem)
This action resets the cellular modem. Specify the modem module and port in the <module> and <port>
elements. This action does not take any parameters.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<cellmodem>
<module>{module}</module>
<port>{port}</port>
<reset/>
</cellmodem>
</interfaces>
</data>
</action>
</rpc>]]>]]>
• {module}
The module number for the cellular modem.
• {port}
The port number for the cellular modem.
Section6.2.4
at (Cellular Modem)
This action sends an AT command to the cellular modem. The command must begin with the prefix AT. Specify
the modem module and port in the <module> and <port> elements. This action takes a single parameter:
<command>.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<interfaces xmlns="http://ruggedcom.com/ns/rmf_ifs">
<cellmodem>
<module>{module}</module>
<port>{port}</port>
<at>
<command>{atCommand}</command>
</at>