Siemens RX1400 - Admin Namespace Actions; Interfaces Namespace Actions

Chapter 6
RUGGEDCOM ROX II Actions
RUGGEDCOM NETCONF
Reference Guide
54 Admin Namespace Actions
Action Path to Action in RUGGEDCOM ROX II
Section6.2.11, “clear-cable-stats-port (Switch Port)”
interfaces» switch{interface}» diagnostics» clear-cable-stats-
port
Section6.3.1, “ntp-status” services» time» ntp» ntp-status
Section6.3.2, “log (Link-Failover)” services» link-failover{interface}» log
Section6.3.3, “start-test (Link Failover)” services» link-failover{interface}» start-test
Section6.3.4, “cancel-test (Link Failover)” services» link-failover{interface}» cancel-test
Section6.3.5, “show-active-leases (DHCP Server)” services» dhcpserver» show-active-leases
Section6.4.1, “clear-stp-stats (Switch)” switch» spanning-tree» clear-stp-stats
Section6.4.2, “flush-dynamic-rules (Switch)” switch» layer3-switching» flush-dynamic-rules
Section6.4.3, “reset-all-switch-ports (Switch)” switch» reset-all-switch-ports
Section6.4.4, “clear-all-switch-stats (Switch)” switch» clear-all-switch-stats
Section6.4.5, “clear-cable-stats-all (Switch)” switch» clear-cable-stats-all
CONTENTS
• Section6.1, “Admin Namespace Actions”
• Section6.2, “Interfaces Namespace Actions”
• Section6.3, “Services Namespace Actions”
• Section6.4, “Switch Namespace Actions”
• Section6.5, “Tunnel Namespace Actions”
Section6.1
Admin Namespace Actions
This section describes how to perform actions related to administration namespaces using <rpc> messages
through NETCONF.
CONTENTS
• Section6.1.1, “snmp-discover”
• Section6.1.2, “launch-upgrade”
• Section6.1.3, “decline-upgrade”
• Section6.1.4, “rollback-reboot”
• Section6.1.5, “roxflash”
• Section6.1.6, “clear-all-alarms”
• Section6.1.7, “acknowledge-all-alarms”
• Section6.1.8, “shutdown”
• Section6.1.9, “reboot”
• Section6.1.10, “set-system-clock”