Siemens RX1400 - RUGGEDCOM ROX II Actions

RUGGEDCOM NETCONF
Reference Guide
Chapter 6
RUGGEDCOM ROX II Actions
53
RUGGEDCOM ROX II Actions
This section describes how to activate RUGGEDCOM ROX II actions on the device with an <rpc> message through
NETCONF. Actions perform functions directly on the device, such as shutting down the device, rebooting, clearing
port statistics, and more.
To activate most actions, the <rpc> simply specifies the path to the action in the RUGGEDCOM ROX II data model.
Some actions require parameters, such as module and port numbers, object identifiers, and other settings. Where
required, this section describes the parameters for each action.
This section organizes the actions by the RUGGEDCOM namespace in which the actions are found.
Table:Actions and RUGGEDCOM ROX II Web Interface Equivalents
Action Path to Action in RUGGEDCOM ROX II
Section6.1.1, “snmp-discover” admin» snmp» snmp-discover
Section6.1.2, “launch-upgrade” admin» software-upgrade» launch-upgrade
Section6.1.3, “decline-upgrade” admin» software-upgrade» decline-upgrade
Section6.1.4, “rollback-reboot” admin» software-upgrade» rollback-reboot
Section6.1.5, “roxflash” admin» rox-imaging» roxflash
Section6.1.6, “clear-all-alarms” admin» clear-all-alarms
Section6.1.7, “acknowledge-all-alarms” admin» acknowledge-all-alarms
Section6.1.8, “shutdown” admin» shutdown
Section6.1.9, “reboot” admin» reboot
Section6.1.10, “set-system-clock” admin» set-system-clock
Section6.1.11, “restore-factory-defaults” admin» restore-factory-defaults
Section6.1.12, “delete-logs” admin» delete-logs
Section6.1.13, “install-files” admin» install-files
Section6.1.14, “backup-files (Backup Files)” admin» install-files
Section6.1.15, “full-configuration-save” admin» full-configuration-save
Section6.1.16, “full-configuration-load” admin» full-configuration-load
Section6.2.5, “reset (Serial Port)” interfaces» serial» port{interface}» reset
Section6.2.6, “clear-serial-port-stats” interfaces» serial» port{interface}» clear-serial-port-stats
Section6.2.7, “restart-serserver” interfaces» serial» restart-serserver
Section6.2.8, “reset-port (Switch Port)” interfaces» switch{interface}» reset-port
Section6.2.9, “clear-port-stats (Switch Port)” interfaces» switch{interface}» clear-port-stats
Section6.2.10, “start-cable-test (Switch Port)” interfaces» switch{interface}» diagnostics» start-cable-test