Siemens RX1400 - Install-Ca-Certificate (IPSEC)

RUGGEDCOM NETCONF
Reference Guide
Chapter 6
RUGGEDCOM ROX II Actions
install-ca-certificate (IPSEC) 73
<user>{remoteUserName}</user>
<password>{remoteUserPassword}</password>
</install-certificate>
</certificate>
</ipsec>
</tunnel>
</data>
</action>
</rpc>]]>]]>
• {remoteHost}
The hostname or IP address of the remote host.
• {remotePort}
The remote host network port for the ssh protocol,
• {pemFilePath}
The absolute path and file name for the certificate .pem file on the remote host.
• {keyFilePath}
The absolute path and file name for certificate .key file on the remote host.
• {remoteUserName}
A user name on the remote host.
• {remotePassword}
The password for the user name on the remote host.
Section6.5.4
install-ca-certificate (IPSEC)
This action uploads an IPSec ca-certificate to the device. The ca-certificate must be located at a network location
accessible to the device. Parameters include <remote-host>, <remote-port>, <remote_cacert_path>,
<user>, and <password>.
<rpc message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<action xmlns="http://tail-f.com/ns/netconf/actions/1.0">
<data>
<tunnel xmlns="http://ruggedcom.com/ns/rmf_iftunnel">
<ipsec>
<certificate>
<install-ca-certificate>
<remote-host>{remoteHost}</remote-host>
<remote-port>{remotePort}</remote-port>
<remote_cacert_path>{caCertFilePath}</remote_cacert_path>
<user>{remoteUserName}</user>
<password>{remoteUserPassword</password>
</install-ca-certificate>
</certificate>
</ipsec>
</tunnel>
</data>
</action>
</rpc>]]>]]>
• {remoteHost}
The hostname or IP address of the remote host.