Siemens RX1400 - Replacing Data

Chapter 5
Changing Configuration Data
RUGGEDCOM NETCONF
Reference Guide
46 Replacing Data
<running/>
</target>
<source>
<url>file:///standard_config.xml</url>
</source>
</copy-config>
</rpc>]]>]]>
7. Commit the changes:
<rpc message-id="234" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<commit/>
</rpc>]]>]]>
8. Unlock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="235">
<unlock>
<target>
<candidate/>
</target>
</unlock>
</rpc>]]>]]>
9. Unlock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="236">
<unlock>
<target>
<running/>
</target>
</unlock>
</rpc>]]>]]>
Section5.2.3
Replacing Data
To replace an existing configuration value with a new value, do the following:
1. Connect to and log in to the device.
2. Lock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="230">
<lock>
<target>
<running/>
</target>
</lock>
</rpc>]]>]]>
3. Lock the target configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="231">
<lock>
<target>
<candidate/>
</target>
</lock>
</rpc>]]>]]>
4. Discard any configuration changes: