Siemens RX1400 - Page 59

RUGGEDCOM NETCONF
Reference Guide
Chapter 5
Changing Configuration Data
Replacing Data 47
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="232">
<discard-changes/>
</rpc>]]>]]>
5. Issue an <rpc> request with the replace operation:
<rpc message-id="233" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config>
<{root element}
xmlns="{namespace URL}"
xmlns:nc="urn:ietf:params:xml:ns:netconf:base:1.0">
{configuration data with nc:operation="replace" attribute}
</{root element}>
</config>
</edit-config>
</rpc>]]>]]>
• {root element}
The top level element in the data model under which the data is located. Note that you need to declare the
xmlns:nc="urn:ietf:params:xml:ns:netconf:base:1.0" namespace at this point.
• {namespace}
The URL to the RUGGEDCOM namespace for the top level element.
• {configuration data with nc:operation="replace" attribute}
The path to the data to be replaced, with the nc:operation="replace" attribute on the element
containing the data to be replaced.
For example, to replace an existing IP address with a new address, issue the following request.
<rpc message-id="233" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config>
<ip xmlns:nc="urn:ietf:params:xml:ns:netconf:base:1.0"
xmlns="http://ruggedcom.com/ns/rmf_ip">
<ifname>fe-cm-1</ifname>
<ipv4 nc:operation="replace">
<address>
<ipaddress>192.168.1.42/24</ipaddress>
</address>
</ipv4>
</ip>
</config>
</edit-config>
</rpc>]]>]]>
6. Commit the change:
<rpc message-id="234" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<commit/>
</rpc>]]>]]>
7. Unlock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="235">
<unlock>