Siemens RX1400 - Page 117

RUGGEDCOM NETCONF
Reference Guide
Chapter 7
Examples
Configuring OSPF Parameters 105
2. Lock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="231">
<lock>
<target>
<candidate/>
</target>
</lock>
</rpc>]]>]]>
3. Discard uncommitted changes:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="232">
<discard-changes/>
</rpc>]]>]]>
4. Configure the OSPF parameters:
<rpc message-id="233" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target>
<candidate/>
</target>
<config>
<routing xmlns="http://ruggedcom.com/ns/rmf_routing">
<dynamic>
<ospf>
<router-id>192.168.1.43</router-id>
<interface>
<ifname>switch.0022</ifname>
<hello-interval>10</hello-interval>
<dead-interval>
<dead-interval>40</dead-interval>
</dead-interval>
</interface>
</ospf>
</dynamic>
</routing>
</config>
</edit-config>
</rpc>]]>]]>
5. Commit the changes:
<rpc message-id="234" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<commit/>
</rpc>]]>]]>
6. Unlock the candidate configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="235">
<unlock>
<target>
<candidate/>
</target>
</unlock>
</rpc>]]>]]>
7. Unlock the running configuration:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="236">
<unlock>
<target>
<running/>
</target>
</unlock>