Siemens RX1400 - Page 6


Table of Contents
RUGGEDCOM NETCONF
Reference Guide
vi
Chapter 7
Examples ........................................................................................................ 77
7.1Getting the System Name ........................................................................................................... 80
7.2Getting the ROX Release ............................................................................................................. 80
7.3Getting the Chassis Status ........................................................................................................... 81
7.4Setting the System Clock ............................................................................................................. 81
7.5Acknowledging Alarms ................................................................................................................ 81
7.6Clearing All Alarms ..................................................................................................................... 82
7.7Viewing Alarms ........................................................................................................................... 82
7.8Restoring Factory Defaults ........................................................................................................... 82
7.9Changing the System Name by Locking and Committing ............................................................... 83
7.10Changing the System Name Directly ........................................................................................... 84
7.11Creating a Static VLAN .............................................................................................................. 85
7.12Assigning a PVID on a Port ........................................................................................................ 86
7.13Disabling Spanning Tree on a Specific Port .................................................................................. 87
7.14Configuring an IP Address on a Specific Port ............................................................................... 88
7.15Deleting an IP Address .............................................................................................................. 90
7.16Setting a Static Route ................................................................................................................ 91
7.17Disabling Spanning Tree Globally ............................................................................................... 92
7.18Retrieving all IP Addresses from the Running Configuration .......................................................... 94
7.19Retrieving the Active Routes on a Device .................................................................................... 94
7.20Configuring Static Multicast Routing on a Layer 3 Device ............................................................. 95
7.21Enabling Static Multicast Routing on a Layer 3 Device .................................................................. 96
7.22Retrieving Static Multicast Status on a Layer 3 Device .................................................................. 97
7.23Replacing an IP Address ............................................................................................................. 98
7.24Configuring a Port to Dynamically Obtain an IP Address ............................................................... 99
7.25Configuring OSPF Area and Network on a Layer 3 Device ........................................................... 100
7.26Enabling the OSPF Passive-Default Option ................................................................................. 102
7.27Configure an OSPF Non-Passive Port ......................................................................................... 103
7.28Configuring OSPF Parameters ................................................................................................... 104
7.29Enabling the OSPF redistribute-connected Option ...................................................................... 106
7.30Enabling OSPF on a Layer 3 Device .......................................................................................... 107
7.31Retrieving OSPF Status ............................................................................................................ 108
7.32Retrieving All Data from the Routing Namespace ....................................................................... 109
7.33Configuring DHCP Server ......................................................................................................... 109
7.34Configure the DHCP Server Port Listening for DHCP Client Requests ............................................. 110
7.35Enabling the DHCP Server Service ............................................................................................. 112
7.36Disabling an Ethernet Port ....................................................................................................... 113
7.37Enabling an Ethernet Port ........................................................................................................ 114
7.38Checking an IP Address on a Specific Port using the Interfaces Namespace ................................... 115