Siemens RX1400 - Page 90

Chapter 7
Examples
RUGGEDCOM NETCONF
Reference Guide
78
NETCONF Example Example demonstrates these techniques:
Section7.22, “Retrieving Static Multicast Status on a Layer 3 Device” Querying for running configuration data.
Section7.23, “Replacing an IP Address” Recommended editing procedure.
Replacing data with the nc:operation="replace" attribute.
Section7.24, “Configuring a Port to Dynamically Obtain an IP
Address”
Recommended editing procedure.
Section7.25, “Configuring OSPF Area and Network on a Layer 3
Device”
Recommended editing procedure.
Section7.26, “Enabling the OSPF Passive-Default Option” Recommended editing procedure.
Section7.27, “Configure an OSPF Non-Passive Port” Recommended editing procedure.
Deleting information with the nc:operation="delete" attribute.
Section7.28, “Configuring OSPF Parameters” Recommended editing procedure.
Section7.29, “Enabling the OSPF redistribute-connected Option” Recommended editing procedure.
Section7.30, “Enabling OSPF on a Layer 3 Device” Recommended editing procedure.
Section7.31, “Retrieving OSPF Status” Querying for running configuration data.
Section7.32, “Retrieving All Data from the Routing Namespace” Querying for running configuration data.
Section7.33, “Configuring DHCP Server” Recommended editing procedure.
Section7.34, “Configure the DHCP Server Port Listening for DHCP
Client Requests”
Recommended editing procedure.
Section7.35, “Enabling the DHCP Server Service” Recommended editing procedure.
Section7.36, “Disabling an Ethernet Port” Recommended editing procedure.
Deleting data with the nc:operation="delete" attribute.
Section7.37, “Enabling an Ethernet Port” Recommended editing procedure.
Section7.38, “Checking an IP Address on a Specific Port using the
Interfaces Namespace”
Querying for running configuration data.
Section7.39, “Retreiving All Data From Running Database Including
Default Values”
Querying for configuration data (including values) from a running
database.
Section7.40, “Retreiving All Data From Running Database Including
Default Tags and Values”
Querying for configuration data (including tags and values) from a
running database.
Section7.41, “Changing a User's Password” Querying for configuration data (including tags and values) from a
running database.
Section7.42, “Displaying the Status of the IPsec Service” Displaying the status of the running IPSec service.
Section7.43, “Selecting a Certificate for an IPSec Tunnel” Selecting a certificate to use for an IPSec tunnel.
Section7.44, “Installing a CA Certificate” Installing a CA certificate to the device.
Section7.45, “Configuring a Signed CA Certificate” Configuring a signed CA certificate.
Section7.46, “Installing a Private Key to a Signed CA Certificate” Installing a private key to a signed CA certificate.
Section7.47, “Installing a CRL File” Installing a CRL file to the device.
Section7.48, “Removing a Certificate” Removing a certificate from the device.
Section7.49, “Removing a CA certificate” Removing a CA certificate from the device.