Siemens S7-300 - 1.3 Guide to commissioning fail-safe signal modules

Product overview
1.3 Guide to commissioning fail-safe signal modules
Fail-safe signal modules
Installation and Operating Manual, 01/2010, A5E00085586-10
17
1.3 Guide to commissioning fail-safe signal modules
Introduction
The table below lists all important tasks related to the commissioning of fail-safe signal
modules in S7-300 or ET 200M.
Commissioning sequence, starting with the selection of the F-SMs
Table 1- 5 Commissioning sequence, starting with the selection of the F-SMs
Step Procedure See
1. Selecting the F-SMs to be installed Product catalog;
chapter
Digital modules;
chapter Analog module
2. Setup of the mode of operation (standard or safety mode),
configuration and parameterization of the F-SM
Chapter Configuring and
parameter assignment;
chapter Addressing and
installing
3. Installing F-SMs Chapter Addressing and
installing
4. Wiring the F-SMs Chapter Wiring
5. Commissioning of the F-SMs ET 200M Distributed I/O
Device manual, or S7-300,
CPU 31xC and CPU 31x
Operating Manual
Installation
6. Run diagnostics if commissioning was not successfully
completed.
Chapter Fault reactions and
diagnostics;
Chapter
Digital Module;
Chapter Analog Module