Siemens S7-300 - 3.2 Parameter Assignment

Configuration and parameter assignment
3.2 Parameter Assignment
Fail-safe signal modules
Installation and Operating Manual, 01/2010, A5E00085586-10
27
3.2 Parameter Assignment
Assigning the module properties
To assign parameters for the fail-safe signal modules, select the module in STEP 7 HW
Config
and then select the Edit > Object Properties menu command.
The parameters you download from the programming device to the F-CPU are saved to CPU
memory, and are then transferred by the F-CPU to the fail-safe signal module.
Note
SFC 56 "WR_DPARM" (changing module parameters in the user program) is not permitted
for fail-safe signal modules.
Parameter description
For information on the assignable parameters of fail-safe modules, refer to the chapters
dealing with digital and analog modules.
PROFIsafe address and PROFIsafe address assignment
The description of the PROFIsafe address and of addressing is available in the chapter
Addressing .