Siemens S7-300 - Application 2: Standard Mode with High Availability

Analog modules
9.2 SM 336; AI 6 x 13 Bit
Fail-safe signal modules
Installation and Operating Manual, 01/2010, A5E00085586-10
195
Assignable parameters for application 1
Table 9- 5 Parameters for application 1 of SM 336; AI 6 x 13Bit
Parameters Range of values in standard mode Type Effective range
"Inputs 1" tab
Enable diagnostic
interrupt
Activated/deactivated Static Module
Interference frequency 50 Hz/60 Hz Static Module
Group diagnostics Activated/deactivated Static Channel
Wire-break check (only
for 4 to 20 mA)
Activated/deactivated Static Channel
Measurement type
 Deactivated
 4DMU
 2DMU
 V
Static Channel
Measuring range
 4 to 20 mA
 0 to 20 mA
 0 to 10 V
static channel
"Inputs 2" tab
Safety mode No (standard mode) Static Module
Monitoring time — Static Module
"Redundancy" tab
Redundancy none Static Module
9.2.5 Application 2: standard mode with high availability
Introduction
Below are the wiring schemes and the parameter assignment of SM 336; AI 6 x 13Bit for
● Application 2: standard mode with high availability
Diagnostic messages, possible causes of the problem and their corrective measures are
found in tables
Diagnostic messages of SM 336; AI 6 x 13Bit and Diagnostic messages and
associated corrective measures for SM 336; AI 6 x 13Bit
in chapter "Diagnostic Messages
for SM 336; AI 6 x 13 Bit (Page 215)".