Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
144 Configuration Manual, 08/2018, C79000-G8976-C267-13
The "Services" list shows the security settings.
●
You configure the setting in "System > Configuration".
– Enabled: Encrypted access to the CLI.
– Disabled: No encrypted access to the CLI.
●
You configure the setting in "System > Configuration".
– HTTP/HTTPS: Access to the WBM is possible with HTTP and HTTPS.
– HTTPS: Access to the WBM is now only possible with HTTPS.
●
You can configure setting in "System > SNMP > General".
– "-" (SNMP disabled)
Access to device parameters via SNMP is not possible.
– SNMPv1/v2c/v3
Access to device parameters is possible with SNMP versions 1, 2c or 3.
– SNMPv3
Access to device parameters is possible only with SNMP version 3.
●
You configure the setting in "Security > Management ACL".
– Enabled: Restricted access only: Access is restricted using an Access Control List
(ACL).
– Disabled: No access restriction: Management ACL is not enabled.
– Enabled: No access restriction: Management ACL is enabled, but access is not
restricted using an Access Control List (ACL).
To Next Page
Loading...
Need help?
General
