Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
242 Configuration Manual, 08/2018, C79000-G8976-C267-13
You can create a rule for the daylight saving time changeover.
●
Enter the following values for the start of daylight saving time:
– Hour
Specify the hour.
– Month
Specify the month.
– Week
Specify the week.
You can select the first to fifth or the last week of the month.
– Day
Specify the weekday.
●
Enter the following values for the end of daylight saving time:
– Hour
Specify the hour.
– Month
Specify the month.
– Week
Specify the week.
You can select the first to fifth or the last week of the month.
– Day
Specify the weekday.
SNTP Client
Time-of-day synchronization in the network
SNTP (Simple Network Time Protocol) is used for synchronizing the time in the network. The
appropriate frames are sent by an SNTP server in the network.
Note
To avoid time jumps, make sure that there is only one time server in the network.
To Next Page
Loading...
Need help?
General
